LEMON Manuals: Even more car manuals for everyone

Oil Pump Installation

  1. Make sure the No. 1 piston top dead center (TDC) mark (A) lines up with the pointer (B).
    Fig 1: Aligning No. 1 Piston Top Dead Center (TDC) Mark With Pointer
    G06265686Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Align the dowel pin (A) on the rear balancer shaft with the mark (B) on the oil pump.
    Fig 2: Aligning Dowel Pin On Rear Balancer Shaft With Mark On Oil Pump
    G06265687Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. To hold the rear balancer shaft, insert a 6 mm pin driver (A) into the maintenance hole in the lower balancer shaft holder and through the rear balancer shaft.
    Fig 3: Inserting Pin Driver Into Maintenance Hole In Lower Balancer Shaft Holder
    G06265688Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Apply engine oil to the threads of the oil pump sprocket mounting bolt (A).
    Fig 4: Oil Pump Sprocket Mounting Bolt, Oil Pump, Oil Pump Sprocket And Pin Driver With Torque Specifications
    G06265689Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Loosely install the oil pump (B), then install the oil pump sprocket (C).
  6. Remove the 6 mm pin driver (D).
  7. Tighten the oil pump mounting bolts.
  8. Squeeze the new oil pump chain tensioner (A), then install the set clip (B) on it as shown.
    NOTE: The set clip is supplied with the oil pump chain tensioner.
    Fig 5: Identifying Oil Pump Chain Tensioner And Set Clip
    G06265690Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Install the new oil pump chain tensioner.
    Fig 6: Oil Pump Chain Tensioner With Torque Specifications
    G06265691Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Remove the set clip from the oil pump chain tensioner.
    Fig 7: Removing Set Clip From Oil Pump Chain Tensioner
    G06265692Courtesy of AMERICAN HONDA MOTOR CO., INC.
  11. Install the oil pan (see OIL PAN INSTALLATION ).