LEMON Manuals: Even more car manuals for everyone

Front Door Outer Handle Replacement

NOTE: Put on gloves to protect your hands.
  1. Raise the glass fully.
  2. Remove the door panel and inner handle (see Front Door Panel Removal/Installation  ).
  3. Disconnect the power door lock actuator connector (A).
    Fig 1: Identifying Power Door Lock Actuator Connector, Plug Caps And Plastic Cover
    G06267991Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the plug caps (B), then remove the plastic cover (C), as needed.
  5. Detach the rod fastener (A).
    Fig 2: Identifying Rod Fastener
    G06267992Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Remove the maintenance cap (A). With a clip remover, disconnect the outer handle rod (B).
    Fig 3: Identifying Maintenance Cap And Outer Handle Rod
    G06267993Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Driver's side: Pull both side flanges (A) of the retainer (B) outward, and pull the middle flange portion (C) of the outer casing cover (D) out, then disconnect the cylinder cable (E) from the latch.
    Fig 4: Identifying Side Flanges And Retainer, Middle Flange Portion, Outer Casing Cover And Cylinder Cable
    G06267994Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Remove the bolt, then remove the spacer (A).
    Fig 5: Spacer With Torque Specifications
    G06267995Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Remove the bolt securing the outer handle protector (A), then remove the protector by releasing the hook (B).
    Fig 6: Outer Handle Protector And Hook With Torque Specifications
    G06267996Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. If necessary, remove the special screws, then separate the door cylinder (A) and outer handle protector (B). If the retainer (C) is damaged, release the hooks (D), and replace it.
    NOTE: If removed, the special screws must be replaced.
    Fig 7: Identifying Door Cylinder, Outer Handle Protector, Retainer And Hooks
    G06267997Courtesy of AMERICAN HONDA MOTOR CO., INC.
  11. While pulling the outer handle (A), remove the handle from the holes in the door panel. Take care not to scratch the door.
    Fig 8: Identifying Outer Handle
    G06267998Courtesy of AMERICAN HONDA MOTOR CO., INC.
  12. Remove the rod fastener (A) from the outer handle (B), then replace it with a new one.
    Fig 9: Identifying Rod Fastener And Outer Handle
    G06267999Courtesy of AMERICAN HONDA MOTOR CO., INC.
  13. Install the handle in the reverse order of removal, and note these items:
    • Make sure the cylinder cable and each rod is connected securely.
    • Make sure the door key cylinder/door locks operate properly.
    • Make sure the door handle works properly.
    • When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
    • Check for water leaks.