Trunk Lid Latch Replacement
- Remove the trunk lid trim (see TRIM REMOVAL/INSTALLATION - TRUNK LID ).
- Disconnect the cylinder rod from the lock cylinder (see step 1 on ).
- Disconnect the trunk lid opener cable (A), and disconnect the power trunk lid actuator connector (B). Take care not to kink the opener cable.
- Remove the bolts from the trunk lid latch (A).
- Pull the trunk lid latch (A) out, and disconnect the cylinder rod (B) from the trunk lid latch. Take care not to bend the cylinder rod.NOTE: Check for a damaged or stress-whitened rod fastener (C).
- Install the latch in the reverse order of removal, and note these items:
- Replace the rod fastener if it is damaged.
- Make sure the connector is plugged in properly and the opener cable is connected properly.
- Make sure the trunk lid opens properly and locks securely.
- Fix at the original position in the outer end of cable (A) on the trunk lid latch securely. And check the trunk lid latch operation: Make sure the trunk lid latch unlock when pulling the trunk lid opener/fuel fill door opener. If necessary, adjust the position of the cable end.