Removal and Installation: Removal
- Make sure you have the anti-theft codes for the radio and the navigation system, then write down the channels for the XM radio presets. Make sure the ignition switch is OFF.
- Disconnect the battery negative cable, then disconnect the positive cable, and wait at least 3 minutes.
- Remove the left front door sill trim and left kick panel (see TRIM REMOVAL/INSTALLATION - DOOR AREAS ).
- Disconnect the connectors from the fuse side of the underdash fuse/relay box (A).
- Remove the two mounting bolts and pull the fuse/relay box away from the body.
- Disconnect the connectors and remove the underdash fuse/relay box.NOTE: Some SRS harness connectors are spring-loaded lock type (see BACKPROBING SPRING-LOADED LOCK CONNECTORS ).
- If replacing the fuse/relay box, carefully remove the relays by prying under the base of the relay.NOTE: Do not use pliers to remove the relays.