LEMON Manuals: Even more car manuals for everyone

Timing Belt: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect negative battery cable. Raise and support vehicle. Remove left front wheel. Remove left front wheelwell splash shield. Remove all drive belts. Remove power steering pump with hoses attached. Set power steering pump aside.
  2. Remove valve cover and upper timing belt cover. See Figure . Turn crankshaft counterclockwise to bring No. 1 piston to TDC of its compression stroke. Position UP mark on sprockets at top. See Figure .
    NOTE: To set camshafts at TDC for No. 1 cylinder, align holes in camshafts with holes in No. 1 camshaft with holes in No. 1 camshaft holders and drive 5.0 mm pin punches in holes to hold camshaft in position. See Figure or Fig 1 .
    Fig 1: Installing Pin Punches in Camshaft
    G50E06805Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Align grooves on sprockets. Remove crankshaft pulley. Remove left engine mount bolts and nut. Remove engine mount. Remove lower timing belt cover. Loosen timing belt tension adjuster bolt. Push tensioner to relieve tension on timing belt. Retighten adjuster bolt. If reusing timing belt, mark direction of belt rotation before removing. Remove timing belt.