Cylinder Head: Installation
WARNING: This page is about a different variant/trim than selected.
- Install new intake manifold gasket. Install intake manifold onto cylinder head. Tighten nuts in a crisscross pattern, beginning with inner nuts. See TORQUE SPECIFICATIONS TABLE at the end of this article.
- Ensure No. 1 piston is at TDC. Apply a light coat of engine oil to cylinder head bolts and washers. Install longer cylinder head bolts into positions 1 and 2. Install remaining bolts. Tighten cylinder head bolts to specification, in sequence, in 2 stages. See Figure .
- Reverse removal procedure to complete installation. If reusing timing belt, install belt with arrow mark (made in removal procedure) in direction of original rotation. Adjust timing belt tension. See TIMING BELT TENSION ADJUSTMENT under ADJUSTMENTS. Fill and bleed cooling system. See BLEEDING COOLING SYSTEM under REMOVAL & INSTALLATION.