Clutch Assembly: Removal
WARNING: This page is about a different car, the 1993 Honda Civic del Sol and 1993 Honda Civic. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative and positive battery cables. Remove battery base and air cleaner and tube assembly. Disconnect starter and transaxle ground cables. Remove engine harness clamp. Disconnect speedometer sensor connector. Disconnect back-up light switch.
- Remove clutch pipe bracket and clutch release cylinder. Drain transaxle fluid. Remove starter. Remove engine and right wheelwell splash shields. Remove header pipe. Separate lower control arms from ball joints. Remove right radius rod. Using 2 large screwdrivers, pry both drive shaft inner CV joints out of transaxle. Protect drive shaft ends.
- Remove header pipe bracket. Remove shift and extension rods. Remove splash guard and front stopper bracket. Install hoist at proper places on engine, and lift engine slightly to unload engine mounts.
- Place a jack under transaxle, and slightly raise jack to take weight off transaxle mounts. Remove front transaxle mount. Remove rear transaxle mount bracket. Remove side transaxle mount. Remove transaxle housing mount bolts. Pull transaxle away from engine, and remove transaxle.