LEMON Manuals: Even more car manuals for everyone

Clutch Assembly: Inspection

WARNING: This page is about a different car, the 1993 Honda Civic del Sol and 1993 Honda Civic. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check pressure plate diaphragm spring fingers for wear and unevenness on release bearing contact area. Check spring finger height using feeler gauge and Clutch Disc Aligner Assembly (07JAF-PM7012A and 07936-3710100 ).
  2. Verify clearance between tool flange and finger is at least .03"(0.8 mm) for new pressure plate and at most .04" (1.0 mm) for existing pressure plate. If necessary, install Ring Gear Holder Assembly (07924-PD20003 or 07LAB-PV00100 ) to hold flywheel stationary while removing pressure plate and clutch disc.
  3. With pressure plate and clutch removed, inspect pressure plate surface for wear, cracks, burning and warpage. Maximum face warpage is .006" (.15 mm). Measure using straightedge and feeler gauge at several points.
  4. Inspect clutch disc lining for slipping, excessive wear, burning and oil contamination. Measure disc thickness and rivet depth. Check for loose rubber torsion dampers. Replace disc if any dampers are loose. Check disc runout. See CLUTCH SPECIFICATIONS  .
  5. Inspect flywheel ring gear teeth for excessive wear and damage. Inspect flywheel surface for wear, burning and cracks. Check flywheel runout and flywheel pilot bearing.